What are the advantages of electric hoist in use?
The so-called wire rope hoist is fixed on the crane by means of the wire rope, and the movement effect is realized by the tightness of the wire rope. In the process of using the wire rope hoist, if you want to ensure the ideal performance of the equipment and at the same time ensure a reliable safety guarantee, then you must make good installation steps. The following is detailed information.
Step 1: Installation of wire rope hoist: main beam lifting ring installation
In order to play a stable role in the hoist installation, it is necessary to use the main material lifting ring. The specific number of lifting rings is determined according to the structure of the hoist itself. There are 4 sets and 2 sets more commonly. If there are 4 sets, usually the volume is installed separately. On the main beam, it plays an important role in fixing. It is also necessary to remind everyone here that during the installation of the main beam ring, we must pay attention to the degree of tightness and installation distribution, because some rings are not equal in model;
Wire rope hoist installation step two: determine the installation direction through the triangular plate
When the hoist is installed, it is necessary to keep the installation object and the installed body on the same horizontal line, and human eye focusing is basically impossible. In order to maintain the same horizontal line, a triangular support plate needs to be used to determine the installation direction.
Wire rope hoist installation step four: install the small frame
In the process of using the wire hoist, a manual trolley is generally needed. Generally, 4 manual trolleys will be installed. During the installation process, it needs to be fixed on the driving axle. Here is a reminder that the fixed trolley is used. Cylindrical pin fixing, through the use of cylindrical pin, not only plays a role in fixing, but also can fix the cable slider;
Step 5 of wire rope hoist installation: built-in buffer
The buffer is an important speed adjustment device during the use of the hoist. The built-in buffer is usually installed on the main beam of the jack. If it is not installed on the main beam, the buffer period can also be installed on the end cover and the rail opening. Can not leave the main beam, because it is necessary to ensure that the main beam on the built-in buffer and the wire rope hoist are in contact at the same time;
Step 6 of wire rope hoist installation: distance maintenance
It was also mentioned above that the hoist must be installed on the main beam ring, but here we need to remind everyone that even if this condition is met, the distance needs to be reasonably controlled;
The above is the detailed installation steps of the wire rope hoist. In each step of installation, you need to pay attention to the general direction while not neglecting the details.
