Safety tips for installation and use of manual hydraulic pallets
The manual hydraulic pallet truck is a small-volume hydraulic device, small in body, light in weight, capable of working in narrow passages and fully loaded into the elevator. Manual hydraulic pallet trucks are mainly used in places where horizontal handling is required and places are crowded. Because of their compact body, flexible movement, light weight and good environmental performance, they are widely used in factories and warehouses where horizontal handling is required. Safety tips for installation and use of manual hydraulic pallet trucks:
1. The safety valve of the truck must be calibrated according to the specified load.
2. The calibration height must be at the attachment just off the ground.
3. It is strictly prohibited for untrained non-professionals to repair and debug the safety valve.
4. It is strictly forbidden to repair and debug the safety valve on the slope.
5. When adjusting the safety valve, the operator's hands or feet are not allowed to be placed under the weight or fork.
6. It is strictly prohibited for untrained non-professionals to assemble and repair unloading valves, control valves, etc.
7. The end of the screw of the "G" clamp must be welded with a ring, and the ring hole must be sleeved with the No. 1 part, otherwise the danger of personal injury may occur.
8. After the plunger pump is assembled, pressure test is required. If oil leakage occurs, it may be damaged when the oil seal is installed and needs to be replaced and reinstalled.
